logo fulling motor
hybrid stepper

HYBRID STEPPER

A stepper motor is an electromechanical device which converts electrical pulses into discrete mechanical movements. The shaft or spindle of a stepper motor rotates indiscrete step increments when electrical command pulses are applied to it in the proper sequence. The motors rotation has several direct relationships to these applied input pulses. The sequence of the applied pulses is directly related to the direction of motor shafts rotation. The speed of the motor shafts rotation is directly related to the frequency of the input pulses and the length of rotation is directly related to the number of input pulses applied. Wide range of Gearboxes also available

brushless motor

BRUSHLESS MOTOR

A brushless DC motor (BLDC) is a synchronous electric motor which is powered by direct-current electricity (DC) and which has an electronically controlled commutation system, instead of a mechanical commutation system based on brushes. In such motors, current and torque, voltage and rpm are linearly related. Wide range of Gearboxes also available

pm_stepping_motor

PM STEPPING MOTOR

Often referred to as a “tin can” or“ can stack” motor the permanent magnet step motor is a low cost and low resolution type motor with typical step angles of 7.5 to 15° (48 – 24steps/revolution) PM motors as the name implies have permanent magnets added to the motor structure. The rotor no longer has teeth as with the VR motor. Instead the rotor is magnetized with alternating north and south poles situated in a straight line parallel to the rotor shaft. These magnetized rotor poles provide an increased magnetic flux intensity and because of this the PM motor exhibits improved torque characteristics when compared with the VR type.

ac servo motor

AC SERVO MOTOR

A Servo Motor is defined as an automatic device that uses an error-correction routine to correct its motion. The term servo can be applied to systems other than a Servo Motor; systems that use a feedback mechanism such as an encoder or other feedback device to control the motion parameters. Typically when the term servo is used it applies to a 'Servo Motor' but is also used as a general control term, meaning that a feedback loop is used to position an item.

SIZE All 40 60 80
Rated Torque All 0.32 1.27 3.18
special solutions

special solutions

Fulling Motor can develop all kinds of stepping motor, DC motor, AC motor, DC brushless driver, Mechanical Component to match customer demands. Our strong R/D team will be available for any special request. If you don't find what you are looking for in our catalog don't esitate to conatct us See here some of our Special Solutions.

news & events BRUSHLESS DC MOTORS – Can different voltages be applied other than the specified voltage?

Yes, you can apply different voltages, although, you must keep in mind that there is a speed limit for the bearings. If you increase the voltage, the speed will increase. If you decrease the voltage then the speed will decrease. For example, if a Brushless DC Motor is rated to run at 3000 RPM no load with 36VDC, the motor will run 2000 RPM with24VDC. The maximum speed, torque, and power are directly proportional to the voltage.